TM 5-3895-383-24
Illustration 284
4.
Carefully disconnect the electrical connectors. Make
not of the position of the connector in order to properly
reconnect the connector.
Illustration 285
5.
Remove the four nuts from the mounting bolts. The
nuts are located at each corner of the platform.
6.
Four pins are needed when you tilt the platform. The
pins are stored under the platform on the front side.
Illustration 286
7.
Install one pin in the hole on each side of the platform.
There is one set of holes that is aligned on each side of
the machine. The pins must be through the holes.
8.
Attach an appropriate lifting device to the platform.
Carefully raise the platform.
NOTE:
Do not attach the lifting device to the brackets
that hold the hood down. The brackets are
connected to the frame of the machine and the
brackets are not connected to the platform.
Illustration 287
9.
Continue raising the platform until the front set of holes
are aligned. Install the pins in the holes. The pins must
be through the holes.
10.
Carefully release the tension in the lifting device.
11.
In order to lower the platform, reverse the procedure for
raising the platform.
Maintenance Section
Platform Tilting
1-118
