TM 5-3895-382-24
Axle Propel Motor
Remove & Install Axle Propel Motor 5058-010
At operating temperature, the oil in the hydraulic oil tank
and in the hydraulic system is hot and under pressure.
Hot oil can cause burns. Prior to disconnecting any
hydraulic lines, release the pressure in the hydraulic
system. Stop the engine. Move the hydraulic control
levers to all positions to release the pressure in the
hydraulic system. Release the pressure in the hydraulic
oil tank. Remove the fill cap on the hydraulic oil tank only
when it is cool enough to touch with your bare hand.
Remove the fill cap slowly to release the pressure in the
hydraulic oil tank.
1.
Release the pressure in the hydraulic system (16-11).
2.
Open the engine access door on the right side of the
machine.
3.
Disconnect hose assembly (1) from the axle propel
motor. Cap and plug immediately.
4.
Disconnect hose assemblies (2) and (5) from axle
propel motor (3). Cap and plug immediately.
5.
Remove two bolts (4), and use two persons to remove
axle propel motor (3) from the rear reduction case
assembly. The weight of the axle propel motor is 23 kg
(51 lb).
NOTE: For installation of the axle propel motor, reverse
the removal steps.
NOTE: After the axle propel motor has been installed, fill
the hydraulic oil tank to the correct level. See the
Operation & Maintenance Manual for the correct
filling procedure.
16-88
