TM 5-3895-382-24
Wheels & Tire Assemblies
Remove & Install Wheels & Tire
Assemblies 4202-010
Tools Needed
A
8S-7640
Stand
2
8S-7611
Tube
2
8S-7615
Pin
2
8S-8048
Saddle
2
NOTE:
The procedure that follows is for either or both
wheel and tire assemblies.
1.
Engage the parking brake. Place wooden wedges in
front of and behind the drum assembly.
NOTE:
The shipping weight of the Roller with pad-foot
shell kit is 18,252 lbs (8279 kgs).
2.
Raise the rear of the machine until the tires are just off
the floor. Install tooling (A) under the rear frame of the
machine as shown.
3.
Remove eight lug nuts (2). Use two persons to remove
wheel and tire assembly (1). The weight of the wheel
and tire assembly is 100 kg (220 lb). When installing
the wheel and tire assembly, tighten the lug nuts to a
torque of 530 ± 70 N· m (390 ± 52 lb-ft).
4.
Check the condition of the wheel studs. If the studs are
damaged, use new pans for replacement.
NOTE:
For installation of the wheel and tire assemblies
reverse the removal steps.
16-83
