TM 5-3895-382-24
Disassemble Axle Propel Motor
5058-015
Tools Needed
A
B
C
D
1P-1862
Pliers
1
1P-3075
Puller Group
1
1P-1860
Pliers
1
2P-8312
Pliers
1
Start By:
a.
remove axle propel motor
1.
Thoroughly clean the outside of the hydraulic propel
motor prior to disassembling it.
2.
Put an alignment mark across the housing and front
cover for assembly purposes.
3.
Remove seven screws (1) that hold the front cover to
the housing. Remove front cover (2) and the shaft as a
unit. Remove the gasket from the housing. At this time,
the hydraulic oil can be drained from the housing.
NOTE:
Up-type seal (4) will be damaged during removal
from the front cover.
4.
Use Tool (A) to remove snap ring (3). Use Tool (B) to
remove lip-type seal (4) from the front cover.
5.
Use Tool (A) to remove snap ring (5). Remove the
bearing and shaft (6) from the front cover as a unit. It
may be necessary to use a press to remove the shaft
and bearing from the front cover.
16-89
