TM 5-3895-382-24
Remove & Install Wheel End Assemblies
(CS-433C & CP-433C) 4051-010
Tools Needed
A
B
C
5P-9736
Link Bracket
1
6V-2157
Link Bracket
1
5S-4087
Socket
1
Start By:
a.
remove wheel and tire assemblies
NOTE:
In the following procedure, the axle assembly was
removed for better photo illustration of the wheel
end assemblies. The axle assembly does not
have to be removed from the machine in order to
service the wheel end assemblies.
1.
Rotate the wheel end assembly so the fill/drain plug is at
the bottom. Drain the oil from the wheel end assembly.
The capacity of the wheel end assembly is 1.4 liters
(.34 U.S. gal).
2.
Put an alignment mark on the planetary spider assembly
and the wheel hub assembly for assembly purposes.
Remove sixteen bolts (1) that hold planetary spider
assembly (2) to the wheel hub assembly.
3.
Install three forcing screws (3) of the appropriate size in
the planetary spider assembly as shown. Tighten the
screws evenly to separate the planetary spider
assembly from the wheel hub assembly, but do not
entirely remove the planetary spider assembly.
4.
Remove the top forcing screw from the planetary spider
assembly. Fasten Tool (A) and a hoist to planetary
spider assembly (2) as shown. Completely separate the
planetary spider assembly from the wheel hub assembly
with the forcing screws. Weight of the planetary spider
assembly is 19 kg (42 lb).
16-84
