TM 5-3895-382-24
5.
Disassemble the planetary spider assembly as follows:
a.
If necessary, remove thrust button (4) from the
planetary spider assembly with a press.
b.
Remove snap ring (5), washer (6) and planetary
gear (7). Remove the other two planetary gears
the same way. Discard the snap rings, and use
new parts for replacement.
c.
Remove three set
screws (9). Remove
planetary shaft (8) with a press as shown.
Remove the other two planetary shafts the same
way.
6.
Remove snap ring (10) from the end of the axle shaft,
and discard it. Use new parts for replacement. Remove
sun gear (11) from the end of the axle shaft.
7.
Remove axle shaft (12) and ring gear (13) from the
wheel hub assembly.
8.
Remove pin (14). Remove bearing adjusting nut (15)
with Tool (C).
9.
Fasten tool (B) and a hoist to wheel hub assembly (16)
as shown. Remove the wheel hub assembly from the
carrier. It may be necessary to use a soft faced
hammer to free the wheel hub assembly from the
carrier. Weight of the wheel hub assembly is 54 kg
(120 lb).
16-85
