TM 5-3895-382-24
Propel & Vibratory Pumps (CS-433C & CP-433C)
Remove
&
Install
Propel
&
Vibratory
Pumps
(CS-433C & CP-433C) 5070 & 5652-010
Start By:
a.
tilt operators platform
At operating temperature, the hydraulic oil tank is hot and
under pressure. Hot oil can cause burns. Remove the fill
cap on the hydraulic oil tank only when the engine is
stopped, and the fill cap is cool enough to touch with your
bare hand.
1.
Release
the
pressure
in
the
hydraulic
system
(page 16-11).
2.
Drain the hydraulic oil from the hydraulic oil tank into a
suitable container. The capacity of the hydraulic oil tank
is 72 liters (19 U.S. gal).
Vibrator and Propel Pumps (Early).
Vibratory and Propel Pumps (Early).
Vibratory and Propel Pumps (Later).
3.
Disconnect hose assemblies (2) and (3) from vibratory
pump (1). Cap and plug immediately.
4.
Disconnect hose assemblies (5) and (6) from vibratory
pump (1). Cap and plug immediately.
5.
Mark or identify all electrical wires for installation
purposes. Disconnect the two electrical wires from
neutral start switch (7). Remove the cable ties that
fasten the wiring harness to the pumps.
6.
Remove the cotter pin and pin that fastens control cable
(9) to plate (4).
7.
Loosen jam nut (8), and remove control cable (9) from
the bracket. Move the control cable out of the way.
16-73
