TM 5-3895-382-24
5.
Disconnect fitting (5) and hose assembly (7) from
brake/shift valve (2).
6.
Remove three bolts (6) that fasten the brake/shift valve
to the frame.
7.
Move the brake/shift valve to gain access to fitting (8)
and hose assembly (9). Disconnect the fitting and hose
assembly from the brake/shift valve. Cap and plug
immediately. Remove the brake/shift valve from the
machine.
NOTE: For installation of the brake/shift valve, reverse
the removal steps.
NOTE: After the brake/shift valve has been installed, fill
the hydraulic oil tank to the correct level. See the
Operation & Maintenance Manual for the correct
filling procedure.
Disassemble & Assemble Brake/Shift Valve 4282-017
Start By:
a.
remove brake/shift valve
1.
Bend the tabs down on lock (5). Remove nut (1) from
shift coil (4) and nut (2) from brake coil (3). Remove the
lock from the coils. Remove brake coil (3) and shift coil
(4). When installing nuts (1) and (2), tighten the nuts to
a torque of 5.5 to 8.0 N· m (48 to 70 lb-in).
2.
Remove brake valve cartridge (6), shift valve cartridge
(7) and check valve (8) from manifold (9). When
installing brake valve cartridge (6) and shift valve
cartridge (7), tighten the valve cartridges to a torque of
45 to 54 N· m (35 to 40 lb-ft).
16-70
