TM 5-3895-382-24
8.
Disconnect hose assembly (11) from vibratory pump (1).
Cap and plug immediately.
9.
Disconnect the electrical connector for electrical
connectors (10) from the main wiring harness.
Left Side of Engine and Pumps.
Right Side of Engine and Pumps.
NOTE: For photographic purposes, the above two photos
were taken with the pumps and engine removed
from the machine.
10.
Disconnect the hose assemblies from elbows (17). Cap
and plug immediately. The hose assemblies connect
drum propel pump (20) to the drum propel motor.
11.
Disconnect the hose assemblies from elbows (21). Cap
and plug immediately. The hose assemblies connect
axle propel pump (22) to the axle propel motor.
12.
Disconnect the hose assemblies from elbows (12). Cap
and plug immediately. The hose assemblies connect
axle propel pump (22) to the vibratory flushing valve.
13.
Disconnect the hose assemblies from elbows (13). Cap
and plug immediately. The hose assembles connect
drum propel pump (20) to the vibratory flushing valve.
14.
Disconnect the hose assemblies from elbows (14) and
(19). Cap and plug immediately. The hose assemblies
connect drum propel pump (20) to the brake interlock
valve.
15.
Disconnect the hose assembles from elbows (15) and
(23). Cap and plug immediately. The hose assemblies
connect axle propel pump (22) to the brake interlock
valve.
16.
Disconnect the hose assembly from elbow (18) on drum
propel pump (20). Cap and plug immediately.
NOTE: The low charge pressure switch is now located
next to the charge oil filter.
17.
Disconnect the hose assembly from fitting (16). Cap
and plug immediately. The hose assembly connects
axle propel pump (22) to the hydraulic oil tank.
16-74
