TM 5-3895-382-24
3.
Remove valve plate (3), gasket (4), needle bearing (5),
and locating pin (6). Needle bearing (5) is press fit in
end cap (2).
NOTICE
During removal of the rotary group (8) from housing (7),
do not let the components fall apart. The piston
assemblies (9) should be installed in their original bores in
the slipper guide (10) and cylinder block (11).
4.
Lay housing (7) on side and remove rotating group (8).
5.
Put identification marks on nine pistons (9) as to their
location in the slipper guide (10) and cylinder block (11).
6.
Remove retainer guide (12), four pins (13), and retainer
(14).
There is spring force against washer (15). When retaining
ring (16) is removed, the spring force will be released. To
prevent possible personal injury, removal of the internal
components in cylinder block (11) should be performed in
a press in order to retain spring (17) and washer (15).
7.
Put cylinder block (11) in a press. Install a suitable drive
plate of the same size as the washer (15). Put a slight
compression on the washer (15) with the press.
Remove the retaining ring (16) and slowly release the
spring compression.
16-53
