TM 5-3895-382-24
15.
If necessary, remove two bearings (14) from steer pivot
(9).
16.
If necessary, remove two bearings (15) from the steer
pivot.
17.
If necessary, remove spherical bearing (16) from the
steer pivot.
NOTE: When installing spherical bearing (16) in steer
pivot (9) the grease holes must be positioned
vertically.
NOTE: For installation of the yoke and steer pivot,
reverse the removal steps.
End By:
a.
install drum assembly
NOTE: After the drum assembly has been installed,
perform the vertical steer pivot clearance,
horizontal steer pivot clearance and oscillation
bearing clearance procedures.
16-51