TM 5-3895-382-24
4.
Use a suitable chain to attach Tool (A) to ROPS (4).
5.
Attach Tool (A) to the lifting hook on operator's platform
(5) as shown.
NOTE:
If the machine is not equipped with a ROPS, use a
lifting strap and hoist to tilt the operators platform
in place of Tool (A).
6.
Use Tool (A) to tilt the operators platform as shown.
Install bolts and nuts (2)(which were removed during
Step 2) to hold operators platform (5) in the tilted
position.
NOTE:
To lower the operators platform, reverse the tilt
steps.
Remove & Install Operators Platform 7352-010
1.
Tilt the operators platform. Refer to the topic "Tilt &
Lower Operators Platform" in this module.
2.
Remove the ROPS (if equipped). Refer to the topic
"Remove
&
Install
ROPS
(Roll-Over
Protective
Structure) in this module.
3.
Turn the battery disconnect switch to the OFF position.
4.
Disconnect four electrical connectors (1).
5.
Disconnect hose assemblies (2) from the fittings on
each of the two steering cylinders. Cap and plug
immediately.
6.
Remove the cotter pin and pin that fastens control cable
(5) to plate (3) on the propel pump.
7.
Loosen jam nut (4), and remove control cable (5) from
the bracket. Move the control cable out of the way.
16-8
