TM 5-3895-382-24
Illustration 22
4.
Install clamp (2) and bolts (1). Tighten bolts (1) to a
torque of 12 Nm (9 lb-f4).
End By:
a.
Install the fuel Injection lines. Refer to Disassembly
and Assembly, "Fuel Injection Lines - Remove and
Install".
Fuel Injection Nozzles- Remove
(Type 2 Engines and 7BJ
Engines)
SMCS Code: 1254-011
Removal Procedure
Start By:
a.
Remove the fuel injection lines. Refer to Disassembly
and Assembly, "Fuel Injection Lines - Remove and
Install".
NOTE:
For a complete description of Type 1 and Type 2
Engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
Illustration 23
1.
Remove bolts (1) from the fuel injection nozzles.
2.
Remove tube assembly (2) from the fuel injection
nozzles.
Illustration 24
7-13
