TM 5-3895-382-24
Illustration 35
Clearance for the inner rotor body (Typical Example)
Clearance of inner rotor to outer
rotor ....................................................................0.040 to 0.130 mm
(.0015 to .0050 inch)
End play of rotor assembly.................................. 0.03 to 0.10 mm
(.001 to .004 inch)
Engine Oil Pressure
SMCS Code: 1924
The minimum oil pressure at low idle with an ambient
temperature of 18 to 20 C (64 to 68 F) is the following
value: ............................................................................62kPa (9 psi)
The minimum oil pressure at high idle and at normal operating
temperature is the following value:
Turbocharged engine .............................. 280 kPa (40 psi)
Tighten the oil pressure switch, which is located on the left side
of the engine block, to the following
torque:................................................7 to 12 Nm (62 to 107 lb-in)
Engine Oil Pan
SMCS Code: 1302
Illustration 36
Oil Pan (Typical Example)
(1)
Tighten the bolts and the nuts of the oil pan to the
following torque: .......................................22 Nm (16 lb-ft)
(2)
Tighten the drain plug of the oil pan to the following
torque: ........................................................34 Nm (25 lb-ft)
Water Temperature Regulator
SMCS Code: 1355
Illustration 37
Opening temperature .........................77 to 85 C (171 to 185 F)
Full open temperature .......................92 to 98 C (198 to 208 F)
5-25
