TM 5-3895-382-24
Width of center journal ....................................44.15 to 44.22 mm
(1.738 to 1.741 inch)
Width of all other journals ...............................39.24 to 39.35 mm
(1.545 to 1.549 inch)
Measure the main bearing journals on the crankshaft. See the
following chart for dimensions.
Table 6
Main Bearing Journal
If the bearing journal has
76.12 mm (2.996 inch)
been ground beyond this
size, then regrind the
bearing journals to the
next undersize journal.
Original Size Journal
76.16 to 76.18 mm
(2.998 to 2.999 inch)
Undersize Journal
75.91 to 75.93 mm
0.25 mm (0.010 inch)
(2.988 to 2.989 inch)
Undersize Journal
75.65 to 75.67 mm
0.51 mm (0.020 inch)
(2.978 to 2.979 inch)
Undersize Journal
75.40 to 75.42 mm
0.76 mm (0.030 inch)
(2.968 to 2.969 inch)
Tighten the bolts for the main bearing journal to the following
torque: ............................................................... 265 Nm (195 lb-ft)
Main bearings are available for remachined journals with the
following undersize dimensions:
Undersize .............................................................0.25 (.010)
Undersize..............................................................0.25 (.010)
Undersize .............................................................0.25 (.010)
Tighten the retaining bolts of the crankshaft pulley (not shown)
to the following torque: ..................................................... 115 Nm
(85 lb-ft)
Apply Locktite 2431 to the bolts of the crankshaft damper.
Tighten the bolts (not shown) to the following torque:
M8 bolts ......................................................35 Nm (26 lb-ft)
M12 bolts ....................................................75 Nm (55 lb-ft)
Tighten the bolts of the rear oil seal housing to the cylinder
block (not shown) to the following
torque:.....................................................................22 Nm (16 lb-ft)
Tighten the bolts of the rear oil seal housing to the bridge (not
shown) to the following torque:
M6 ................................................................13 Nm (10 lb-ft)
M8 ................................................................18 Nm (13 lb-ft)
Crankshaft Seals
SMCS Code: 1160
Front Oil Seal
Illustration 43
Installation of the front oil seal and wear sleeve for the crankshaft
(1) Crankshaft pulley
(2) Front oil seal
(3) Hub of crankshaft pulley
(4) Wear sleeve
(5) Face front oil seal housing
(A) Depth of front oil seal
The front oil seal (2) is normally installed to a depth of 7.00
0.25 mm (0.2756 0.0098 inch) (A) from the face of the front
oil seal housing (5). The oil seal may cause wear on the hub
of the crankshaft pulley (3). This wear may allow oil leakage
past the oil seal. If this situation occurs, the front oil seal can
be installed to a depth of 9.3 mm (0.37 inch) from the face of
the front oil seal housing.
If a wear sleeve (4) is installed, the front oil seal is installed to a
depth of 9.30 mm (0.366 inch) from the face of the front oil seal
housing. When the wear sleeve is installed, the flange of the
wear sleeve does not require removal. If a wear sleeve is
installed, a new front oil seal must be installed.
5-30