TM 5-3895-382-24 Turbocharger SMCS Code: 1052 Turbocharger Illustration 24 (1) Put oil on the threads of the nut and put oil on the seat face. Tighten the impeller nut to the following torque: ....................................2 to 2.3 Nm (18 to 20 lb-in) Tighten the nut again to the following value: .................................................................110 degrees NOTE: Do  not  bend  or  add  stress  to  the  shaft  when  the nut is tightened. (2) Tighten  the  bolts,  which  hold  the  back  plate,  to  the following torque:  ........................................ 8.5 to 10.2 Nm (75 to 90 lb-in) (3) Put   5P-3931   Anti-Seize   Compound   on   the   threads. Tighten the bolts, which hold the compressor housing to the center section, to the following torque: .......................................................15.3 to 18.7 Nm (12 to 14 lb-ft) (4) Put   5P-3931   Anti-Seize   Compound   on   the   threads. Tighten the bolts, which hold the turbine housing to the center section, to the following torque: .......................................................18.6 to 20.4 Nm (14 to 15 lb-ft) (5) Turbine wheel assembly Minimum journal outside diameter .................. 10.152 mm (.3997 inch) Ring groove diameter (minimum).................... 14.401 mm (.5670 inch) Ring groove width (maximum)  ...........................1.740 mm (.0685 inch) Hub outside diameter (minimum).................... 17.323 mm (.6820 inch) (6) End play for shaft Minimum permissible end play.................................03 mm (.001 inch) Maximum permissible end play................................10 mm (.004 inch) (7) Compressor wheel Bore inside diameter (maximum)........................6.353 mm (.2501 inch) (8) Backplate assembly Seal inside diameter (maximum) .................... 12.713 mm (.5005 inch) Flatness from the backplate to the mating surface of the center housing is within the following value:....................................................013 mm (.0005 inch) (9) Thrust collar Thickness (maximum)....................................... 18.339 mm (0.7220 inch) Bore inside diameter (maximum)........................6.363 mm (.2505 inch) Thrust bearing groove width (maximum)  ..................................... 4.440 mm (.1748 inch) Thrust bearing groove diameter (minimum)  ...................................... 9.398 mm (.3700 inch) Piston ring groove width (maximum) .................1.659 mm (.0653 inch) (10) Thrust bearing Thickness (minimum)...........................................4.359 mm (0.1716 inch) Bore inside diameter (maximum)..................... 10.922 mm (.4300 inch) (11) Radial play (side to side movement) for shaft Minimum permissible radial play (side to side movement)........................08 mm (.003 inch) Maximum permissible radial play (side to side movement) ............................................15 mm (.0059 inch) 5-20