TM 5-3895-382-24
(12)
Center housing
Bearing inside diameter
(maximum) ....................................15.806 mm (.6223 inch)
Seal inside diameter (maximum)..................... 17.805 mm
(.7010 inch)
Put 5P-3931 Anti-Seize Compound on the threads. Tighten
the bolts, which hold the turbocharger to the manifold (not
shown), to the following
torque: .......................................................55 5 Nm (40 4 lb-ft)
Exhaust Manifold
SMCS Code: 1059
Type 1 Engines and 9RM Engines
Illustration 26
Bolt tightening sequence for Type 1 engines and 9RM engines.
The exhaust manifold mounted to the cylinder head.
Refer to Illustration 26 for the tightening sequence. Tighten the
plated nuts for the exhaust manifold to the following
torque:.....................................................................44 Nm (33 lb-ft)
Refer to Illustration 26 for the tightening sequence. Tighten the
nuts that are not plated for the exhaust manifold to the
following torque:....................................................50 Nm (37 lb-ft)
Type 2 Engines and 7BJ Engines
Illustration 27
Bolt tightening sequence for Type 2 engines and 7BJ engines
Refer to Illustration 27 for the tightening sequence. Tighten the
12 nuts for the exhaust manifold gradually to the following
torque: ....................................................................33 Nm (24 lb-ft)
5-21