TM 5-3895-382-24 (11) Tighten the head locking screw to the following torque:  ................3.0 to 3.6 Nm (27 to 35 lb-in) (12) Tighten the discharge fitting to the following torque: ............................. 70.5 to 81.4 Nm (52 to 60 lb-ft) (13) Tighten the fuel line nut to the following torque: ........................................................18 Nm (13 lb-ft) (14) Tighten the end cap of the transfer pump to the following torque:  ...................41 to 50 Nm (30 to 37 lb-ft) (15) Tighten the nut of the end cap for the transfer pump to the following torque: .................18 Nm (13 lb-ft) Tighten the nut of the drive gear (not shown) to the following torque:  ...................................................80 Nm (59 lb-ft) Table 1 Timing Chart For Fuel Injection Pumps Part Number For Fuel Injection Pump Part Number For Reman Pump Supplier Part Number Type of Engine Code Letters On Fuel Pump Engine Check Angle (TC) (Degrees) Pump Mark Angle (Degrees) 6I-1173 OR-4540 2643U201 3054 NA KM 282 290 6I-1216 OR-4541 2643U201 3054 T LM 282 292 6I-2477 OR-4542 2643U203 3054 T MM 282 295 101-3876 - 2643U204 3054 NA SM 282 291 101-4359 - 2643U205 3054 T TM 282 290.5 108-9623 - 2643U206 3054 T ZM 282 289 110-8005 - 2643U207 3054 NA AC 282 291 114-2472 - 2643U212 3054 T HC 282 291 114-4340 - 2643U209 3054 T TM 282 290.5 115-1163 - 2643U208 3054 NA SM 282 291 119-1536 - 2643U215 3054 NA KM 282 290 119-7294 OR-8297 2643U213 3054 T LM 283 295 119-7295 OR-8298 2643U214 3054 T MM 283 295 121-3223 - 2644C108 3054 - n/a n/a 123-2937 - 2644C701 3054 - n/a n/a 127-2230 - 2644C702 3054 T SC 294 340 130-1416 - 2643U222 3054 T UC 282 295 130-5392 - 2643U221 3054 T LM 283 295 130-3774 - 2643U220 3054 NA KM 282 290 148-2950 - U2644F402 3054 - n/a n/a 152-3934 - U2644F101 3054 - n/a n/a 156-0218 - U2644C712 3054 - n/a n/a (1) “NA” Naturally Aspired, “T” Turbocharged 5-6