TM 5-3895-382-24
(9)
If damaged, remove elbow (11) from tee (7).
(10)
If damaged, remove tee (7) and connector (12) from oil filter head assembly (13).
(11)
If damaged, remove connector (12) from tee (7).
b. Installation.
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give
off harmful vapors, and are harmful
to skin and clothing. To avoid injury
or death, keep away from open fire
and use in a well-ventilated area. If
adhesive,
solvent,
or
sealing
compound gets on skin or clothing,
wash immediately with soap and
water.
(1)
If removed, apply sealing compound to threads of connector (12) and install on tee (7).
(2)
If removed, apply sealing compound to threads of tee (7) and install in oil filter head assembly (13).
(3)
If removed, apply sealing compound to threads of elbow (11) and install in elbow (11).
(4)
Apply sealing compound to threads of adapter (9) and install in elbow (11).
NOTE
When installing engine oil sampling valve, position drain of valve downward to
ease in collection of sample.
(5)
Install seal (10) on engine oil sampling valve (2).
(6)
Install on adapter (9). Tighten locking nut (8).
(7)
Install hour meter pressure switch (6) on tee (7) and tighten to 7 lb-ft (22 Nm).
(8)
Connect hour meter pressure switch connector (4) to connector (5).
(9)
Install engine oil sampling valve drain cap (1) on engine oil sampling valve (2).
NOTE
Follow-on Maintenance:
·
Fill engine to capacity with engine oil.
·
Start engine (TM 5-3895-382-10) and check for leaks.
·
Remove chocks.
END OF TASK
2-23
