TM 5-3895-382-24
(1)
Start engine and run engine at low idle (TM 5-3895-382-10).
(2)
Remove engine oil sampling valve drain cap (1) from engine oil sampling valve (2).
(3)
Place container with 1 qt (0.9 1) minimum capacity under engine oil sampling valve (2).
(4)
Turn and hold knurled knob (3) in direction of arrow until engine oil sample is collected. Release knob when
sample has been collected.
(5)
Install engine oil sampling valve drain cap (1) on engine oil sampling valve (2).
(6)
Shut engine off (TM 5-3895-382-10).
(7)
Submit engine oil sample to your local Army Oil Analysis Program (AOAP) laboratory for analysis.
NOTE
Follow-on Maintenance:
Unlock steering pin (TM 5-3895-382-10).
Check engine oil level (TM 5-3895-382-10).
Close right side door assembly (TM 5-3895-382-10).
Remove chocks.
END OF TASK
2-21
