TM 5-3895-382-24
e. Cleaning/Inspection.
WARNING
·
Drycleaning Solvent (P-D-680, Type III) is TOXIC and flammable. Wear protective goggles and
gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and, do
not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the
flashpoint for drycleaning solvent type III is 200° F (93C). Failure to do so may result in injury
or death to personnel.
·
If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes,
immediately flush eyes with water and get immediate medical attention.
(1)
Clean all metal parts with drycleaning solvent.
WARNING
Compressed air is used for cleaning purposes and shall not exceed 30 psi (207 kPa). Use only
with effective chip guarding and personal protective equipment (goggles, gloves, etc.).
(2)
Dry all parts with compressed air.
(3)
Inspect bumper assembly for rust, cracks, dents, bends, broken or cracked welds, and holes.
(4)
Inspect drum assembly for rust, cracks, dents, bends, broken or cracked welds, and holes.
(5)
Repair or replace all damaged parts.
2-16
