TM 5-3895-379-23
TROUBLESHOOTING PROCEDURES - CONTINUED
0006 00
Table 2. Electrical Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Starting Aid Switch Does Not Work - 2. Check for power at starting aid 1. If 24 to 28 Vdc are not measured
6.
switch. Press starting aid switch
at terminal 1, turn engine start
Continued.
forward to start position (TM 5-
switch and battery disconnect to
3895-379-10). Set multimeter to
OFF position (TM 5-3895-379-
measure Vdc, touch positive (+)
10). Replace start aid switch (WP
(wire 376-GN) and negative (-)
ground.
2. If 24 to 28 Vdc are measured at
terminals 1, turn engine start
switch and battery disconnect
switch to OFF position (TM 5-
3895-379-10). Repair or replace
wiring and connectors from
starting aid switch to starting aid
assembly on operator station with
three washers and screws. Install
vandal guard on box assembly
with two washers and shoulder
screws.
VANDAL
GUARD
WASHER
TERMINAL 1
WIRE 376-GN
SHOULDER
SCREW
TERMINAL 2
STARTING
WASHER
AID SWITCH
WIRE 148-WH
BOX ASSEMBLY
SCREW
401-203
0006 00-73