TM 5-3895-379-23-2
0255
REMOVAL
WARNING
Oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may cause
injury.
1.
Remove hydraulic oil sampling valve drain cap (Figure 1, Item 4) from hydraulic oil sampling valve
(Figure 1, Item 5).
NOTE
Use drain pan to catch any hydraulic oil that may drain from system. Dispose of oil IAW local
policy and ordinances. Ensure all spills are cleaned up.
2.
Place drain pan with 1 qt (0.9 Liter) minimum capacity under hydraulic oil sampling valve
(Figure 1, Item 5).
3.
Turn and hold knurled knob (Figure 1, Item 6) in direction of arrow and allow remainder of hydraulic oil to drain.
4.
Loosen locking nut (Figure 1, Item 3) on hydraulic oil sampling valve (Figure 1, Item 5) and remove hydraulic
oil sampling valve from tee (Figure 1, Item 1).
5.
Remove O-ring (Figure 1, Item 2) from hydraulic oil sampling valve (Figure 1, Item 5). Discard O-ring.
1
2
3
6 5 4
M0823SWR
Figure 1. Hydraulic Oil Sampling Valve Removal.
6.
If damaged, remove tee (Figure 2, Item 4) from hydraulic oil pump (Figure 2, Item 1).
7.
Remove cap (Figure 2, Item 2), preformed packing (Figure 2, Item 3), boss reducer (Figure 2, Item 6), and two
O-rings (Figure 2, Item 5) from tee (Figure 2, Item 4).
03/15/2011Rel(1.8)root(maintwp)wpno(M00193)