TM 5-3895-379-23-1
0206
ASSEMBLY
1.
Install switch (Figure 4, Item 23) and three screws (Figure 4, Item 24) on pivot bracket (Figure 4, Item 22).
2.
Install pivot bolt (Figure 4, Item 21) on pivot plate (Figure 4, Item 20) using same number of turns noted during
removal.
NOTE
Install washers as noted in removal.
3.
Install outer bracket (Figure 4, Item 26), three washers (Figure 4, Item 18), two wires (Figure 4, Item 27), and
bronze wear shoe (Figure 4, Item 19) to pivot bolt (Figure 4, Item 21).
4.
Install adjuster (Figure 4, Item 11), boot (Figure 4, Item 13), and boot sleeve (Figure 4, Item 12).
5.
Install, but do not tighten nut (Figure 4, Item 10). Install handle pipe (Figure 4, Item 9) and tighten nut.
6.
Install two screws (Figure 4, Item 28) and wires (Figure 4, Item 27) on vibration push switch (Figure 4, Item 5).
7.
Install two retaining rings (Figure 4, Item 15), pivot pin (Figure 4, Item 25), and two cams (Figure 4, Item 16).
8.
Lower boot (Figure 4, Item 13) and install two screws (Figure 4, Item 14) and cam (Figure 4, Item 17).
9.
Install nut (Figure 4, Item 7) and new preformed packing (Figure 4, Item 8) to handle pipe (Figure 4, Item 9).
10.
Install two new gaskets (Figure 4, Item 2) to handles (Figure 4, Item 1).
11.
Install two handles (Figure 4, Item 1) to handle pipe (Figure 4, Item 9).
NOTE
Grip housings will not fit together if any threads of handle pipe are showing on top side
of nut while nut is installed.
Mate flat sides of nut with cavity on grip housing.
Use care not to lose any nuts during installation. Nuts are small and easily lost.
12.
Install two screws (Figure 4, Item 29), four screws (Figure 4, Item 30), and six nuts (Figure 4, Item 6) to two
handles (Figure 4, Item 1).
CAUTION
Do not turn handle more than one full turn. Handle should not be forced or turned more than
needed to tighten. Forcing the handle to turn further will damage the handle.
13.
Tighten handle (Figure 4, Item 1) on handle pipe (Figure 4, Item 9) by turning grip housings clockwise not more
than one full turn.
14.
Install retainer ring (Figure 4, Item 3) and boot (Figure 4, Item 4) to handle (Figure 4, Item 1).
0206-6
03/15/2011Rel(1.8)root(maintwp)wpno(M00144)