TM 5-3895-379-23-1
0206
DISASSEMBLY
1.
Remove retainer ring (Figure 3, Item 3) and boot (Figure 3, Item 4) from handle (Figure 3, Item 1).
CAUTION
Do not turn handle more than one full turn. Handle cannot be removed by unscrewing and
should not be forced or turned more than needed to allow access to screws and nuts. Forcing
the handle to turn further will damage the handle.
2.
Loosen handle (Figure 3, Item 1) on handle pipe (Figure 3, Item 9) by turning handle counterclockwise not
more than one full turn.
NOTE
Use care to not lose nuts during removal. Nuts are small and may stay with handle.
3.
Remove two screws (Figure 3, Item 29), four screws (Figure 3, Item 30), and six nuts (Figure 3, Item 6) from
two handles (Figure 3, Item 1).
4.
Remove two handles (Figure 3, Item 1) from handle pipe (Figure 3, Item 9).
5.
Remove two gaskets (Figure 3, Item 2) from handles (Figure 3, Item 1). Discard gaskets.
6.
Remove nut (Figure 3, Item 7) and preformed packing (Figure 3, Item 8) from handle pipe (Figure 3, Item 9).
Discard preformed packing.
NOTE
Note that cams are different lengths.
7.
Raise boot (Figure 3, Item 13) and remove two screws (Figure 3, Item 14) and cam (Figure 3, Item 17).
8.
Remove two retaining rings (Figure 3, Item 15), pivot pin (Figure 3, Item 25), and two cams
(Figure 3, Item 16).
9.
Remove two screws (Figure 3, Item 28) and wires (Figure 3, Item 27) from vibration push switch
(Figure 3, Item 5).
10.
Loosen nut (Figure 3, Item 10) and remove handle pipe (Figure 3, Item 9).
11.
Remove nut (Figure 3, Item 10), adjuster (Figure 3, Item 11), boot (Figure 3, Item 13), and boot sleeve
(Figure 3, Item 12).
NOTE
Note position of washers to aid in installation.
Count number of turns necessary to remove pivot plate from pivot bolt.
12.
Remove outer bracket (Figure 3, Item 26), three washers (Figure 3, Item 18), two wires (Figure 3, Item 27),
and bronze wear shoe (Figure 3, Item 19) from pivot bolt (Figure 3, Item 21).
13.
Remove pivot plate (Figure 3, Item 20) from pivot bolt (Figure 3, Item 21).
14.
Remove three screws (Figure 3, Item 24) and switch (Figure 3, Item 23) from pivot bracket (Figure 3, Item 22).
0206-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00144)