TM 5-3895-379-23-1
0201
REMOVAL
NOTE
Refer to Repair Parts and Special Tools Lists (TM 5-3895-379-23P) for identification.
Main wiring harness can be repaired without being removed from roller. Refer to (Volume
2, WP 0280) for repair instructions as needed.
Tag and mark all wires prior to removal to aid in installation.
Cut electrical tiedown straps as needed for removal. Discard electrical tiedown straps.
Note position and routing of main wiring harness as it is disconnected and removed to
aid in installation.
1.
Disconnect main harness wire terminals from drum offset switch connector
(TM 5-3895-379-23P, Figure 63, Item A).
2.
Disconnect main harness wire terminals from cutter switch connector
(TM 5-3895-379-23P, Figure 63, Item B).
3.
Disconnect main harness wire terminals from drum select switch connector
(TM 5-3895-379-23P, Figure 63, Item C).
4.
Disconnect main harness wire terminals from dual amp switch connector
(TM 5-3895-379-23P, Figure 63, Item D).
5.
Disconnect main harness connector from work light control switch connector (WP 0162).
6.
Disconnect main harness wire terminals from water spray switch connector (WP 0157).
7.
Disconnect main harness connector from auto man switch connector
(TM 5-3895-379-23P, Figure 63, Item G).
8.
Disconnect main harness connector from front/rear pump switch connector
(TM 5-3895-379-23P, Figure 63, Item J).
9.
Disconnect main harness connector from fuel solenoid resistor connector (WP 0175).
10.
Disconnect main harness connector from turn signal switch connector
(TM 5-3895-379-23P, Figure 63, Item L).
11.
Disconnect main harness connector from engine oil pressure switch connector (WP 0172).
12.
Disconnect main harness connector from water temperature sending unit relay connector (WP 0182).
13.
Disconnect main harness connector from warning light relay connector (WP 0180).
14.
Disconnect main harness connector from hydraulic oil temperature relay connector (WP 0185).
15.
Disconnect main harness connector from light circuit breaker connector (WP 0173).
16.
Disconnect main harness connector from instrument wiring harness connector (WP 0199).
17.
Disconnect main harness connector from functional light relay connector (WP 0199).
18.
Disconnect main harness connector from recording module connector
(TM 5-3895-379-23P, Figure 63, Item T).
19.
Disconnect main harness connector from diagnostic warning diode assembly connector
(TM 5-3895-379-23P, Figure 63, Item U).
20.
Disconnect main harness connector from engine wiring harness connector (WP 0196).
21.
Disconnect main harness connector from backup alarm pressure switch connector (WP 0181).
0201-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00139)
