TM 5-3895-379-23-1
0200
REMOVAL - Continued
24.
Disconnect main harness wire terminals from fuel solenoid resistor connector (WP 0175).
25.
Disconnect main harness wire terminals from turn signal switch connector
(TM 5-3895-379-23P, Figure 63, Item AF).
26.
Disconnect main harness connector from engine oil pressure relay connector (WP 0172).
27.
Disconnect main harness connector from water temperature sending unit connector (WP 0182).
28.
Disconnect main harness connector from warning light relay connector (WP 0180).
29.
Disconnect main harness connector from hydraulic oil temperature relay connector (WP 0185).
30.
Disconnect main harness connector from functional indicator light relay connector (WP 0177).
31.
Disconnect main harness connector from instrument wiring harness connector (WP 0199).
32.
Disconnect main harness wire terminals from diagnostic warning diode assembly connector
(TM 5-3895-379-23P, Figure 63, Item AP).
33.
Disconnect main harness connector from engine wiring harness connector (WP 0196).
34.
Carefully remove main wiring harness from roller.
END OF TASK
INSTALLATION
NOTE
Install new electrical tiedown straps as necessary.
1.
Position loose wiring harness in general installation position.
2.
Connect main harness connector to engine wiring harness connector (WP 0196).
3.
Connect main harness connector to diagnostic warning diode assembly connector
(TM 5-3895-379-23P, Figure 63, Item AP).
4.
Connect main harness connector to instrument wiring harness connector (WP 0199).
5.
Connect main harness connector to functional indicator light relay connector (WP 0177).
6.
Connect main harness connector to hydraulic oil temperature relay connector (WP 0185).
7.
Connect main harness connector to warning light relay connector (WP 0180).
8.
Connect main harness connector to water temperature sending unit relay connector (WP 0182).
9.
Connect main harness connector to engine oil pressure relay connector (WP 0172).
10.
Connect main harness wire terminals to turn signal switch connector
(TM 5-3895-379-23P, Figure 63, Item AF).
11.
Connect main harness wire terminals to fuel solenoid resistor connector (WP 0175).
12.
Connect main harness wire terminals to vibration control switch connector (WP 0159).
13.
Connect main harness wire terminals to amplitude select switch connector (WP 0160).
14.
Connect main harness wire terminals to drum select switch connector
(TM 5-3895-379-23P, Figure 63, Item AB).
15.
Connect main harness connector to drum offset switch connector (TM 5-3895-379-23P, Figure 63, Item Z).
16.
Connect main harness connector to work light control switch connector (WP 0162).
0200-3
03/15/2011Rel(1.8)root(maintwp)wpno(M00138)
