TM 5-3895-379-23-1
0133
ADJUSTMENT
CAUTION
Make sure rod linkage is attached before connecting the engine speed control solenoid to
prevent damage to the engine speed control solenoid.
1.
Align the engine speed control solenoid (Figure 3, Item 7) with governor control shaft (Figure 3, Item 1).
2.
Move the engine speed switch to HIGH position (TM 5-3895-379-10).
3.
Battery disconnect switch in OFF position (TM 5-3895-379-10).
4.
Move the key switch to ON position to energize engine speed control solenoid (Figure 3, Item 7). Do not start
engine.
5.
Loosen locknuts (Figure 3, Item 3) on rod linkage (Figure 3, Item 11).
6.
Adjust rod linkage (Figure 3, Item 11) until lever (Figure 3, Item 14) on governor control shaft
(Figure 3, Item 1) contacts stop for HIGH idle.
7.
Tighten locknuts (Figure 3, Item 3) on rod linkage (Figure 3, Item 11).
8.
Cycle the engine speed switch to ensure lever (Figure 3, Item 14) contacts HIGH idle stop.
9.
Manually move plunger of engine speed control solenoid (Figure 3, Item 7) and check for binding of linkage.
Adjust linkage as needed.
6
5
4
7
1
2
3
14
2
11
13
12
10
9
8
M1301SWR
Figure 3.
Throttle Control Adjustment.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00071)
