SECTION 9
STEERING
v. Check the condition of the column assembly,
clean it, and replace on the unit with two capscrews
oriented as before. Rotate the steering shaft while
bringing the surfaces into contact to allow splines to
engage (see figure 9-64). If in doubt, follow the
orientation as shown. Tighten capscrews to 23.3 ft.-lbs.
(3.22 kg-m) (see figure 9-65).
9-28. INSTALLATION OF STEERING CONTROL
UNIT.
9-29. Install the steering control unit by reversing
procedure presented in paragraph
9-19. Install hydraulic hoses per illustration figure 9-66.
CAUTION: Complete bleeding the system procedure
paragraph 9-83 before returning unit to
service.
FIGURE 9-64
FIGURE 9-62
FIGURE 9-63
FIGURE 9-65
9-17.