SECTION 8
FINAL DRIVE
u.
Position drum hub loosely against drive wheel.
gear. Tighten capscrews until splined gear is flush with
Use three place bolts equally spaced to initially pull hub
bearing (see figure 8-43).
against ring gear (see figure 8-40).
y.
Install the drive drum following the procedure
presented in Section 7, paragraph 7-203. Fill final drive
CAUTION:
Do not align puller holes of the drum with
with specified lubricant (refer to Section 4).
those of the ring gear.
z.
Install scraper bar and bumper assembly.
v.
Remove puller bolts and install the 16 drum
hub capscrews.
Torque in a circular pattern to
specification (see figure 8-41).
CAUTION:
Follow transmission start-up procedure
w.
Manufacture a puller per illustration in figure 8-
before returning unit to service.
42.
x.
Assemble
special
puller
onto
splined
\
FIGURE 8-39.
FIGURE 8-41.
FIGURE 8-42.
FIGURE 8-40.
FIGURE 8-40.
8-12