SECTION 8
FINAL DRIVE
mounting flange and paint it with "Loctite Plastic Gasket"
h.
Install the large snap ring (see figure 8-27).
or equivalent (see figure 8-30).
i.
Press the oil seal into the drum hub until it
bottoms against the snap ring (see figure 8-28).
I.
Do the same to the mating machined surface of
the drum (see figure 8-31).
j.
Assembly of Inner Planetary Assembly. Install
the interlocking sun gear in planetary carrier and lock it in
m.
Install the ring gear using a pilot stud. Using
place with the snap rings. Place the planetary carrier on a
four capscrews, seat the ring gear in the drum. Remove
protective surface with the long hub of the interlocked sun
the four capscrews (see figure 8-32).
gear down (see figure 8-29).
n.
Insert thrust washer first, then needle thrust
k.
Installation of the Planetary System. If the ring
bearing into the machined pilot of the interlocked sun gear
gear
has
been
removed,
clean
its
of the inner planetary assembly using a heavy machine
grease to hold them in the pilot (see figure 8-33).
FIGURE 8-31.
FIGURE 8-33.
FIGURE 8-34.
FIGURE 8-32.
8-10.