SECTION 8
FINAL DRIVE
the ring gear, and push this assembly into the drum until it
o.
Install the small sun gear on the brake shaft.
bottoms against the thrust washers (see figure 8-38).
Then install the snap ring into its retaining groove (see
NOTE: Check to see that the two planetary carriers do
p.
Assemble brake shaft into inner planetary gear
not touch. Also, check that the thrust needle
(see figure 8-35).
bearings have not fallen out of place.
Planetaries must be removed if these conditions
q.
Install inner planetary into ring gear (see figure
are a problem.
t. Paint outer face of ring gear with "Locktite Plastic
r.
Apply a large amount of lubriplate. Insert thrust
Gasket" or equivalent. Apply Lubriplate to machine boss
washer first and then assemble needle bearing into outer
of outer planetary (see figure 8-39).
planetary (see figure 8-37).
s.
Lift the outer planetary assembly into the ring
gear,
meshing
the
planetary
pinions
with
FIGURE 8-37.
FIGURE 8-35.
FIGURE 8-38.
FIGURE 8-36.
8-11.