SECTION 8
FINAL DRIVE
o. Pry out the snap ring with a large screwdriver or
NOTE: Since the planetary pinions are extremely hard,
medium size pry bar; Replace if worn or scored (see
a punch is not effective. To mark these
planetary pinions, paint a small portion of each
gear with a light color paint and etch either 1, 2,
p. Turn the drum hub over and place it in an arbor
or 3 on each gear.
press. Using an appropriate size pusher, press out the
large bearing (see figure 8-12).
NOTE: The planetary carrier can be marked corre-
spondingly with a punch.
q. Place the inner planetary assembly on a protected
surface with the interlocked sun gear down.
s. With the planetary pinion gears and carrier properly
marked, unlock and remove one pinion gear capscrew,
r. Clean the webbed portion of each of the three
lockplate and spacer (see figure 8-14).
planetary pinion gear and mark their position with
respect to the planetary carrier (see figure 8-13).
t. Push the pinion gear riding pin out of the
FIGURE 8-12
FIGURE 8-14
FIGURE 8-15
FIGURE 8-13
8-5.