SECTION 7
TRANSMISSION
1/16 in. (1.59 mm) gap between swivel and wire stop
b. Adjust and tighten ball joint of control cable at
(see figure 7-44).
bail shaft end. Adjust neutral start safety (transmission
g. Adjust ball joint in slotted crank on bail shaft to
lockout) switch so that it makes contact in neutral.
allow full throttle when bail is moved to either full
c. Move Direction-Throttle Control Ball in the
forward or full reverse.
forward direction until control cable at servo lever has
h. Adjust friction control nuts and spring assembly
traveled 11/16 - 31 /32 In.(24.64 - 26.92 mm). Adjust
so that Direction-Throttle Control Bail will remain in any
ball stops so that cable cannot be moved beyond this
desired position.
point.
d. Repeat step c In reverse direction.
7-173.
THROTTLE
CONTROL
LINKAGE
CAUTION:
Ensure that the amount of ball (control
cable) travel is limited by bail stops and not the interval
ADJUSTMENT PROCEDURE (see figure 7-44).
servo stops.
a. Adjust transmission control linkage per
e. Return Direction-Throttle Control Bail to neutral
procedure outlined in paragraph 7-172 (Sundstrand).
(vertical) position.
f. Adjust and tighten wire stop at throttle crank for
FIGURE 7-44
7-35