87.
Gear Shifting Becomes Hard
Possible remedy
Probable cause
Adjust master clutch (par. 140b).
Master clutch out of adjustment.
Repair or replace linkage (par. 145).
Linkage twisted or bent
Shift gears when the engine is running at idling speed.
Gears not meshing.
Combine the operation of the gearshift lever with the
forward and reverse lever until proper gear meshing
is achieved.
Shift the gears when the engine is running at idling
Engine speed too high.
speed.
88.
Bakes Fail
Possible remedy
Probable cause
Connect linkage (par. 148).
Linkage disconnected.
Repair, adjust, or replace linkage (par. 148).
Linkage twisted, bent, or obstructed.
Adjust or replace linkage (par. 148).
Too much play in linkage and pins.
Replace brake lining (par. 208). See note in paragraph
Brake lining worn out.
Adjust brake (par. 141b).
Brake out of adjustment.
Replace brake lining (par. 208). See note In paragraph
Brake lining saturated with oil or grease.
89.
Governor Control Lever Does Not Operate
Possible remedy
Probable cause
Connect linkage (par. 108).
Linkage disconnected.
Inspect, repair, or replace linkage (par. 108).
Linkage twisted, bent, or obstructed.
90.
Sprinkler Pedals Fail
Possible remedy
Probable cause
Connect linkage.
Linkage disconnected.
Inspect, repair, or replace linkage (par. 166).
Linkage bent, twisted, or obstructed.
Open pet cocks.
Sprinkler tank pet cocks closed.
Replace sprinkler valve (par. 166).
Sprinkler valve lever bent or damaged.
Inspect and clean sprinkler lines.
Sprinkler lines clogged.
Fill the sprinkler tank.
Sprinkler tank empty.
91.
Water Does Not Sprinkle Evenly
Possible remedy
Probable cause
Replace sprinkler mats (par. 167).
Sprinkler mats damaged or worn.
Replace sprinkler valves (par. 166).
Sprinkler valves damaged or clogged
Inspect, clean, or replace sprinkler lines (par. 166).
Sprinkler lines leaky or rusted.
92.
Hydraulic Pump Becomes Noisy
Possible remedy
Probable cause
Check connections for oil leaks. Tighten hose clamps
Air bubbles In the oil tank.
Fill the hydraulic oil tank (par. 154).
Oil tank empty.
Replace bearing (par. 210). See note in paragraph 55.
Bearing worn out.
See note in
Replace head gasket (par.
Head gasket blown.
67