TM 5-3895-383-24
Starting Motor
Typical example
6V5821
Rotation as seen from drive end.................................... Clockwise
No load conditions at 25C (77F):
Speed (min)............................................................ 5960 rpm
Speed (max)........................................................... 9326 rpm
Current (min)....................................................................60 A
Current (max) ..................................................................75 A
Voltage .............................................................................23 V
(1)
Battery terminal. Three cables or wire terminals
maximum between nuts. Two cable terminals
maximum with 0 AWG or larger. Tighten nut to
a torque of ........................ 30.5 3.5 Nm (270 31 lb-in)
(2)
Ground terminal. Tighten to a
torque of............................ 30.5 3.5 Nm (270 31 lb-in)
(3)
Switch terminal. Tighten to a
torque of ..............................2.25 0.25 Nm (20 2 lb-in)
Terminal must be insulated with heat-shrink tubing. Do
not use molded terminals.
(4)
Motor frame terminal. Tighten terminal to a
torque of........................................8 ± 3 N m (71 ± 27 lb-in)
(5)
Motor terminal. Tighten terminal to a
torque of............................ 30.5 3.5 Nm (270 ± 31 lb-in)
(6)
Ground terminal. Tighten to
a torque of ........................ 30.5 ± 3.5 N m (270 ± 31 lb-in)
Solenoid:
Current consumption (draw):
Pull-in current at 12 V ....................................................64 A
Hold-in current at 12 V....................................................10 A
Typical example
Typical example
3E1944
6V5720
Rotation as seen from drive end ................................... Clockwise
No load conditions at 25C (77F):
Speed (min) ........................................................... 3215 rpm
Speed (max) .......................................................... 4041 rpm
Current (min)....................................................................68 A
Current (max) ............................................................... 100 A
Voltage ..............................................................................23 V
(1)
Battery terminal. Three cables or wire terminal
maximum between nuts. Two cable terminals
maximum with 0 AWG or larger. Tighten nut to
a torque of ........................ 30.5 ± 3.5 N m (270 ± 31 lb-in)
(2)
Motor frame terminal. Tighten terminal to a
torque of........................................ 8 ± 3 N m (71 ± 27 b-in)
7-20
