TM 5-3895-383-24
Cylinder Block
Right Side (6 Cylinder Shown)
(1)
Depth that cup plugs are installed (measured from block
face to top edge of plug) ............................1.25 ± 0.25 mm
(.049 ± .010 in)
(2)
Distance all dowels extend from
top face ................................................................. 14 ± 2 mm
(.55 ± .08 in)
(3)
Distance two large dowels extend from
rear face.................................. 12.0 ± 0.5 mm (.47 .02 in)
(4)
Distance all dowels extend from
front face................................... 8.0 0.5 mm (.31 .02 in)
View A-A (Rear Face)
(5)
Bores in block for all camshaft bearings except front
bearing ...................................................69.000 ± 0.038 mm
(2.7165 ± .0015 in)
(6)
Locate bearing oil hole for all camshaft bearings (except
front bearing) at top of bore.
Front Face
(7)
Bore in block for front camshaft
bearing ................ 70.000 ± 0.025 mm (2.7559 ± .0010 in)
(8)
Front camshaft bearing joint location.
(9)
Front camshaft bearing oil hole.
NOTE:
Install front camshaft bearing with bearing oil hole
(10) aligned with oil hole in block and bearing
joint (9) positioned as shown.
(10)
Width of main bearing cap ................159.995 ± 0.020 mm
(6.2990 ± .0008 in)
Width of cylinder block for main bearing
cap .....................160.000 ± 0.018 mm (6.2992 ± .0007 in)
(11)
Bore in block for main
bearings .................................................95.000 0.013 mm
(3.7402 ± .0005 in)
(12)
Main bearing cap bolts. Install as follows.
Install bearing caps with sequence number to the right,
1 through 5 (for 4 cylinder) or 1 through 7 (for 6
cylinder), front to rear.
a.
Before assembly, put 4C5593 Thread Lubricant or
clean engine oil on the bolt threads and washer face.
5-25
