TM 5-3895-382-24
24.
Install bearing (8) and shaft (6) as a unit in front cover
(2). Use Tool (A) to install snap ring (5).
25.
Position a new gasket on the pump housing, and lower
the shaft and front cover (2) into position. Carefully
align the shaft splines with the cylinder block splines.
Continue to lower the shaft and front cover into position
while aligning front cover with the swashplate and the
end of the shaft with the beating in the pump housing.
When the shaft and front cover are properly installed,
the spring inside the cylinder block will hold the front
cover away from the pump housing and gasket a
maximum distance of 3 mm (0.125 in).
26.
Install seven twelve point bolts (1) that fasten the front
cover to the pump housing. Tighten the 3/8'-16 X 1.25
in twelve point bolt to a torque of 53 to 64 N· m (39 to
47 lb-ft). Tighten the remaining six 7/16'-14 X 1.00 in
twelve point bolts to a torque of 81 to 100 N· m (60 to
74 lb-ft).
27.
Put clean hydraulic oil on the lip-type seal (4). Slide the
lip-type seal over the shaft, and install the lip-type seal
in the front cover.
28.
Use Tool (A) to install snap ring (3).
29.
If any hydraulic fittings were removed from the axle
propel motor, reinstall them in their original locations.
End By:
a.
Install axle propel motor
16-97
