TM 5-3895-382-24
17.
Put clean hydraulic oil on the slipper face of each piston.
Install sleeve bearing (18) and swashplate (19) in the
housing. Be sure the swashplate is seated on each
piston, and the sleeve bearing is engaged in the groove
in servo piston (36). It may be necessary to move the
servo piston to allow the sleeve bearing to engage
properly.
18.
Install spring (15) and stop (16) in servo piston (36).
19.
Install a new gasket (17), cover (13) and five bolts (11).
Install a new gasket, cover (14) and five bolts (12).
Tighten the bolts to a torque of 13.6 to 17.6 N· m (10 to
13 lb-ft).
20.
Install two spring pins (9) in front cover (22). Spring
pins (9) must protrude 1.65 to 2.03 mm (0.065 to 0.080
in) above the journal bearing surfaces of the front cover.
21.
Install two journal bearings (10) on the front cover and
spring pins (9). The ends of spring pins (9) must not
protrude beyond the surface of the journal bearings after
they are installed.
22.
Install lower snap ring (7) in the lower most groove on
shaft (6). Using a press, install shaft (6) into bearing (8).
Install the shaft until the bearing makes contact with the
snap ring.
23.
Use Tool (C) to install upper snap ring (7) on shaft (6).
16-96
