TM 5-3895-382-24
Every 10 Service Hours or Daily
Walk-Around Inspection
Inspect Machine
1.
Inspect and replace lights, broken bulbs and
lenses.
2.
Inspect and remove any trash build-up in and
around the engine.
3.
Inspect and repair any cooling system or engine
component leaks.
4.
Check the fuel filters for water.
5.
Inspect steps and handholds for condition and
cleanliness. Repair or clean if necessary.
6.
Inspect the hydraulic system for leaks. Inspect the
tank, hoses, tubes, plugs, joints and fittings.
Correct any leaks.
7.
Be sure covers and guards are firmly in place.
Inspect for damage.
8.
Inspect operator's compartment for cleanliness
and remove all trash.
9.
Inspect and repair the instrument panel when
broken gauges and lights are found.
10.
Inspect hydraulic motors for leaks.
11.
Inspect the rubber isolation blocks, between the
vibratory drum and the machine frame for
damage, cracking or splitting. Refer to the Service
Manual or your Caterpillar dealer for the complete
isolation block replacement procedure.
Maintenance Section
Every 10 Service Hours or Daily
1-50
