TM 5-3895-382-24
2.
Remove two bolts (2) and nuts from top of
platform.
3.
Attach an appropriate lifting device to hook (3).
4.
Remove bolts (4) and (5) and nuts from each side
of platform.
5.
Install bolt (4) and nut into center hole on each
side of platform.
6.
Lift platform until bottom holes are aligned. Install
bolt (5) and nut on each side of platform.
7.
Release tension on lifting hook (3).
NOTE: Lower
the
platform
by
reversing
the
procedure for tilting the platform.
Cutting Edges
Check For Wear
Check all cutting edges and bottom wear plates for wear.
The cutting edges can be turned around and used again
one time.
Maintenance Section
When Required
1-49
