TM 5-3895-382-24
V-Belts - Remove and Install
SMCS Code: 1357-010
Removal Procedure
Illustration 228
Typical example.
1.
Remove fan guard (1).
2.
Loosen three bolts (2) and slide alternator (3) toward the
engine.
3.
Maneuver V-belts (4) around the fan and remove the
belts.
NOTE:
Never replace one V-belt. Always replace two V-
belts, if equipped.
Installation Procedure
Illustration 229
Typical example.
1.
Install V-belts (4) behind the fan and on the pulleys.
2.
Slide alternator (3) away from the engine. Tighten three
bolts (2).
NOTE:
Refer to the Specifications Module, "Belt Tension
Chart" for the correct belt tension.
NOTE:
If the V-belt cannot be checked with a gauge,
press on the V-belt at the center of the longest
free length in order to check the deflection. Under
a moderate amount of pressure, the V-belt should
have a deflection of 10.0 mm (.40 inch).
3.
Install fan guard (1).
Fan - Remove & Install
SMCS Code: 1356-010
Removal Procedure
Illustration 230
1.
Remove four bolts (1).
2.
Remove fan (2).
3.
Remove extension (3) that is behind the fan.
4.
Remove the fan pulley, if necessary.
Installation Procedure
Illustration 231
7-89
