TM 5-3895-382-24
Illustration 235
Typical example.
2.
Loosen two nuts (1).
3.
Loosen bolt (4) and slide alternator (3) toward the
engine. Remove V-belt (5) from the engine.
4.
Remove bolt (4) and the washer from alternator (3).
5.
Remove two nuts (1) with the washers and bolts (2).
6.
Remove alternator (3) from the engine.
Installation Procedure
Illustration 236
Typical example.
Illustration 237
Typical example.
1.
Put alternator (3) in position on the engine.
2.
Install two bolts (2) with the washers and nuts (1).
Tighten nuts (1) finger tight. Install bolt (4) and the
washer. Do not tighten bolt (4) at this time.
3.
Put V-belt (5) in position on the engine. Adjust the
tension on V-belt (5) by moving alternator (3) away from
the engine. Tighten bolt (4) after the proper belt tension
is made. For additional information on adjusting the V-
belt, refer to the Operation and Maintenance Manual,
"Alternator and Fan Belts -Inspect/Adjust/Replace".
4.
Tighten nuts (1) in order to secure alternator (3) in
position on the engine.
Electric Starting Motor - Remove
and Install
SMCS Code: 1453-010
Removal Procedure
1.
Place an identification mark on all electrical wires that
are connected to the starting motor. Disconnect the
electrical wires from the starting motor.
7-91
