TM 5-3895-382-24
b.
Cleaning inspection.
WARNING
Drycleaning Solvent (P-D-680, Type III) is TOXIC and flammable. Wear protective
goggles and gloves; use only in a well-ventilated area; avoid contact with skin,
eyes, and clothes; and, do not breathe vapors. Keep away from heat or flame.
Never smoke when using solvent; the flashpoint for drycleaning solvent type III
is 200° F (93° C). Failure to do so may result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If
solvent contact eyes, immediately flush eyes with water and get immediate
medical attention.
(1)
Clean all metal parts with drycleaning solvent.
WARNING
Compressed air is used for cleaning purposes and shall not exceed 30 psi
(207 kPa). Use only with effective chip guarding and personal protective
equipment (goggles, gloves, etc.).
(2)
Dry all parts with compressed air.
(3)
Inspect bumper assembly for rust, cracks, dents, bends, broken or cracked welds, and holes.
(4)
Inspect drum assembly for rust, cracks, dents, bends, broken or cracked welds, and holes.
(5)
Repair or replace all damaged parts.
2-11