TM 5-3895-382-10
Operation Section
4-23
Machine Controls
Propel Speed Range Switch
NOTICE
Stop the machine before changing speed ranges.
Do not change speed ranges while the machine is
moving.
The propel speed range switch, located on the control
console at the right side of the seat, allows machine
operation in either of two ranges.
LOW (1) - Move the propel speed range
switch forward to place the machine in
LOW or working range. This reduces the
overall machine speed allowing increased operator
control.
HIGH (2) - Move the propel speed range
switch back to place the machine in HIGH
or road range. This increases the overall
machine speed and is used when moving the machine
from one job site to another.
NOTE: LOW (1) should be used whenever the
vibratory system is in operation.
Vibratory Control Switch
NOTICE
Stop the system completely before changing the
vibratory amplitude selection.
The vibratory control switch, located on the control
console at the right side of the seat, is used to select
high amplitude, low amplitude or vibratory system off.
LOW (1) - Move the vibratory switch forward for LOW
amplitude.
OFF (2) - Move the vibratory switch to the center
position to shut the vibratory system OFF (static
mode).
HIGH (3) - Move the vibratory control switch back for
high amplitude.
Vibratory Frequency Control Switch
This knob rotates to control the vibratory frequency
between 1400 and 1800 VPM while propelling.
