TM 5-3895-379-23
STEERING CYLINDER REPAIR
0201 00
DISASSEMBLY
1.
Remove two bolts (1), lockwashers (2) and slide cover (3) and rod assembly (4) partially out of cylinder assembly (5).
Discard lockwasher.
2.
Push head (6) into cylinder assembly (5) and remove lockwire ring (7).
3.
Remove head (6) and rod assembly (4) from cylinder assembly (5).
4.
Remove nut (8), piston (9) and head (6) from rod assembly (4).
5.
Remove O-ring (10) from rod assembly (4). Discard O-ring.
6.
Remove wear ring (11) and O-ring (12) from piston (9). Discard wear ring and O-ring.
7.
Remove O-ring (13) and back-up ring (14) from outside of head (6). Discard O-ring and back-up ring.
8.
Remove lip-type seal (15), O-ring (16) and back-up ring (17) from inside head (6). Discard lip-type seal, O-ring and
back-up ring.
14
11
13
6
7
15
9
12
8
4
1,2
401-836
3
5
10
401-836
16
17
ASSEMBLY
NOTE
Inspect all parts and bore of steering cylinder for cracks and damage. Replace if damage is found.
During assembly of steering cylinder, apply a thin coat of clean oil on O-ring, back-up rings and lip-
type seals.
0201 00-2