TM 5-3895-379-23
ROTATE LOCK REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
References
Tools and Special Tools
TM 5-3895-379-23P, Figure 104
Tool kit, general mechanic's (Item 36, WP 0220 00)
Shop equipment, common no. 1 (Item 28, WP 0220
Equipment Condition
Engine off (TM 5-3895-379-10)
Drums chocked (TM 5-3895-379-10)
REMOVAL
1.
Remove four screws (1), washers (2) and rotate lock assembly (3) from operator station (4).
2.
Remove spring pin (5), washer (6), pin (7) and spring (8) from rotate lock assembly plate (3).
3.
Remove two bearings (9) from rotate lock assembly plate (3).
4
5
7
3
9
2
8
1
10
6
9
401-723
INSTALLATION
1.
Install two bearings (9) on rotate lock assembly plate (3).
2.
Install spring (8), washer (6) and pin (7) in rotate lock assembly plate (3).
3.
Compress washer (6) and spring (8) and install spring pin (5) in pin (7).
4.
Install rotate lock assembly (3) on operator station (4) with four washers (2) and screws (1). Do not tighten screws.
5.
Align pin (7) with hole in operator platform (10) and tighten screws to 33-47 lb-ft (45-64 Nm).
6.
Remove chocks (TM 5-3895-379-10).
END OF WORK PACKAGE
