TM 5-3895-379-23
GENERAL WIRING REPAIR - CONTINUED
0108 00
GROUP II TERMINAL ASSEMBLY
1.
Insert new terminal (32) in locating hole of crimp
31
34
32
tool using proper hole according to gauge of wire
(31).
2.
Slide seal (33) down to end of insulation (34).
33
CRIMPING
TOOL
401-553
NOTE
Wire and seal should be positioned so larger wings of terminal will crimp around seal and smaller wings
will crimp around exposed bare wire.
3.
Position wire (31) on terminal (32).
28
4.
Press handles of crimp tool together until ratchet
releases and crimp is complete.
5.
Push new terminal (32) and wire (31) through con-
nector (28) until seated.
32
31
401-554
6.
Close two secondary locks (29) on connector (28).
28
28
7.
Connect connector (28).
8.
Remove chocks (TM 5-3895-379-10).
29
401-550
END OF WORK PACKAGE
0108 00-10