TM 5-3895-379-23
GENERAL WIRING REPAIR - CONTINUED
0108 00
GROUP II TERMINAL DISASSEMBLY - CONTINUED
WARNING
Tip of removal tool is very sharp. Use caution when using tool. Failure to comply may cause injury to
personnel.
3.
Insert removal tool into cavity (30) on connector
REMOVAL TOOL
(28) until seated.
4.
Pull wire (31) back through connector (28) and
28
remove tool.
30
31
32
33
401-551
NOTE
Perform step 5 only if old terminal is still attached to wire.
Make cut directly behind damaged terminal.
5.
Cut terminal (32) and wire seal (33) from wire (31). Discard terminal and seal.
6.
Insert 1 in. (2.5 cm) of wire (31) through new wire
31
seal (33).
CAUTION
33
Strip wire after placing it through seal to
prevent damage to individual wire
strands.
7.
Strip end of wire (31) leaving 1/4 in. (0.64 cm) of
bare wire.
401-552
0108 00-9
