TM 5-3895-379-23
GENERAL WIRING REPAIR - CONTINUED
0108 00
GROUP I TERMINAL ASSEMBLY - CONTINUED
NOTE
Wire should be positioned so larger wings of terminal will crimp around insulation and smaller wings
will crimp around exposed bare wire.
4.
Position wire (26) on terminal (24).
5.
Press handle(s) of crimp tool together until ratchet
releases and crimp is complete.
NOTE
24
Locking tab should be positioned toward
26
notch in connector cavity when properly
26
24
installed.
6.
Pull wire (26) and terminal (24) back through con-
25
nector (25) until seated.
7.
Seat seal (27) into connector (25).
27
401-549
GROUP II TERMINAL DISASSEMBLY
NOTE
Connector is removed by gently prying up on clip and pulling on connector or pushing in on clip on
connector.
All Group II connectors are repaired the same way. Number of wires in connector may vary. The
general shape of Group II connectors may vary.
Both halves of connectors are repaired the same way.
1.
Disconnect connector (28).
28
28
2.
Unlatch and open two secondary locks (29) on con-
nector (28).
29
401-550
0108 00-8